Kawasaki Ninja Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter · #1 ·
Just wondering what existing 400R riders have installed for slip-on exhausts. I know that 650 aftermarket parts work on the 400's, but just wondering with the sleeved engine, would the slip-on exhausts work the same...

None of the exhaust manufacturers are recommending their exhausts for the 400...and it's probably because most of these manufacturers are US based and therefore won't offer anything special for the Canadian or Japanese markets...

Thanks in advance!
 

·
Registered
Joined
·
1,737 Posts
I put a two bros carbon fibre black on black series slipon, sounds great, kinda like a purring lion? Have had it on for about 500 km, no problems. Only had to buy a new o2 sensor, couldn't get the one off of the stock exhaust , had to cot hole and weld bung onto the small pipe that came with the two bros. if u leave the o2 sensor off the light on dash stays on, don't know if it would cause any harm though.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top