Kawasaki Ninja Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hey folks,

I'm intending the install the Black Path Racing sliders onto my 2008 250R. Instructions says to support the engine block when removing engine mounts.

Question: Where do I support the engine at the bottom? The oil filter area or somewhere else? I'm assuming I can use a car pneumatic jack to do the job?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.