Kawasaki Ninja Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Hi Guys/Gals
I wondering if someone can give me a measurement of the thickness of aftermarket handle bar lowering link.
I plan to fabricate up a set of lowering links (front and rear)

Thanks
Sumo
 

·
Registered
Joined
·
13 Posts
Discussion Starter · #3 ·
eric said:
Do you mean these spacers?




They are 5mm thick,each.
Thats the answer I was looking for!!
Thanks Eric, I'm going to fabricate them this weekend!!

Cheers
Sumo
 

·
Registered
Joined
·
331 Posts
I love when people do there own mod.
Just keep in mind that no matter how much you lower you front the hight of you handle bar ralative to the ground will allways be the same.Think about it.You may see the pictuer.
As for the rear.For every cm you temper with the lower link you hight will change 4 cm.I've done a write up on our Thai forum about this.Exept I made the tail higher but the concept is the same.Will make a link for you.Even it's written in Thai but all that pic will tell a thousend words.

http://www.ninja250thailand.com/board/index.php?topic=1313.0
 
1 - 5 of 5 Posts
Top