Kawasaki Ninja Forum banner
1 - 14 of 14 Posts

· Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
After putting on CNC bar ends I took it out for ride the following day and realised I tightened up the throttle side a tad to much. And now I have cruze control coz the throttle slightly sticks. Could this be a problem n should I back of the bar end

i luv ninjaz
 

· Registered
Joined
·
2,270 Posts
gecc081 said:
After putting on CNC bar ends I took it out for ride the following day and realised I tightened up the throttle side a tad to much. And now I have cruze control coz the throttle slightly sticks. Could this be a problem n should I back of the bar end

i luv ninjaz
Of course it's going to be a problem when you roll off the throttle its going to stay and keep you going forward if you hit the brakes too you might lock up and slide off ! You might enter a corner too fast etc etc etc
 

· Registered
Joined
·
615 Posts

· Registered
Joined
·
615 Posts
earlthepearl said:
Think i'd rather have my hand on the throttle in control at all times.
Maybe if i was driving across the roads out west....
where it's a straight road for hundreds of miles it'd be ok.
I thought about it for my interstate commuters. But I only ride about 30 miles round trip so it wouldn't be worth it for me.
 
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top